Making The Electrical Connection - HAMPTON BAY 51398 Guía De Uso Y Cuidado

Assembly - Hanging the Fan (continued)
8

Making the electrical connection

WARNING: Each wire nut supplied with this fan is designed to
accept up to one 12-gauge house wire and two wires from the
fan. If you have larger than 12-gauge house wiring or more than
one house wire to connect to the fan wiring, consult an electrician
for the proper size wire nuts to use.
IMPORTANT: Use the plastic wire connecting nuts (BB) supplied with
your fan and remote control. Secure the connectors with electrical
tape and ensure there are no loose strands or connections.
□
Connect the ground conductor of the 120-Volt supply (this
may be a bare wire or a wire with green colored insulation) to
the green ground lead(s) (II) of the fan using a wire connecting
nut (BB).
□
Connect the fan motor white wire (LL) to the receiver (NN) white
wire (LL) using a plastic wire connecting nut (BB).
□
Connect the fan motor black wire (KK) to the receiver (NN)
black wire (KK) using a plastic wire connecting nut (BB).
□
Connect the fan motor blue wire (JJ) to the receiver (NN) blue
wire (JJ) using a plastic wire connecting nut (BB).
□
Connect the receiver (NN) red wire (OO) to the supply black
(hot) wire (KK) using a plastic wire connecting nut (BB).
□
Connect the receiver (NN) white wire (LL) to the supply white
wire (neutral) (LL) wire using a plastic wire connecting nut (BB).
□
After connecting the wires, spread them apart so that the
green (II) and white (LL) wires are one side of the outlet box
(MM) and the black wire (KK) is on the other side.
□
Turn the plastic wire connecting nuts upward, and carefully
push the wiring into the outlet box (MM).
MM
NN
JJ LL
KK LL
9
Mounting the fan
WARNING: When using the standard ball/downrod mounting, the
tab in the ring at the bottom of the mounting bracket must rest in
the groove of the hanger ball. Failure to properly seat the tab in
the groove could cause damage to the wiring.
□
Align the locking slots of the canopy (C) with the two screws
in the slide-on mounting bracket (A). Push up to engage the
slots, and turn clockwise to lock the canopy (C) in place.
□
Firmly tighten the two mounting screws (M).
□
Install the remaining two mounting screws (M) into the holes
in the canopy (C) and tighten firmly.
□
Install the canopy ring (O) by aligning the ring's slots with the
screws in the canopy (C). Rotate the ring counter-clock-
wise to lock it in place.
M
10
A
O
C
E