Carton Contents - SNOWJOE SUNJOE SJ-CMPS1 Manual Del Operador

Unpacking
NOTE: Before beginning assembly, make sure that all of
the parts listed below are present. If any part is missing or
damaged, do not attempt to assemble the product. Contact
the Snow Joe + Sun Joe customer service department at
® ®
1-866-SNOWJOE (1-866-766-9563).

Carton Contents

• Side panel (x2)
• Drum panel (x7)
• Door panel and 2 doors
• Divider
• Axle
• PVC axle cap (x2)
• A-frame tube section (x2)
• Right angled tube section A (x2)
• Right angled tube section B (x2)
• M5x10 machine screw and nut (x56)
• M6x55 machine screw and nut (x2)
• Manual and registration card
Assembly
Choose a level location for assembly. Remove all parts from
the packaging, and check for missing parts.
1. Attach the door panel to the two drum side panels using 4
M5x10 machine screws and nuts (Fig. 1).
Fig. 1
Side panels
2. Install one of the drum panels under the door panel you
just installed using 7 M5x10 machine screws and nuts
(Fig. 2). Repeat this step for two additional drum panels.
Fig. 2
3. After installing the six panels (2 side panels, 1 door panel
and 3 drum panels), insert the divider between the grooves
on the inside face of the drum panels (Fig. 3).
Fig. 3
4. Afterwards, install the remaining drum panels to complete
Door panel
the composter drum. At this point you may insert the two
doors onto the door panel.
5. Next, press fit both PVC axle caps on either side of the
axle. Then slide the axle through the composter drum
making sure it protrudes from both side panels (Fig. 4).
Fig. 4
3
Drum panel
Divider
Grooves
Axle
PVC Axle
Cap