Installation - Glacier bay 2114SSHD Guía De Uso Y Cuidado

installation (continued)

Installation

8
Preparing the bottom shelf assembly for
shower stall installation
noTe: For tub ledge preparation see step 6.
□ Slip the tapered end of the short tapered tube (D) into
the untapered end of the bottom tube of the assembly.
□ Place the soft vinyl end cap (DD) on the short tapered
tube (D).
9
Shower stall installation
noTe: For tub ledge installation see step 7.
noTe: If needed, the height may be reduced by
carefully cutting the short tapered tube. Refer to the
Troubleshooting section at the end of this manual.
□ Lift the entire assembly into position over the shower stall.
□ Compress the top of the unit against the ceiling at the
desired location.
□ Move the bottom end into place on the shower floor so that
the unit is in a vertical position.
□ Place the tape strips (EE) around the seams of the tubes.
EE
8
bottom shelf assembly
D
DD
the entire assembly