Idiomas disponibles
Idiomas disponibles
Position the plates for best fit
inside the tracks.
or
NOTE:
If screws seem too short and
are not engaging the plate,
take out screw, remove plastic
spacer, use washer only.
In some cases, it may
be easier to assemble
plates, screws, and
bases before sliding
onto tracks.
Installation Tips:
CROSSBAR SPREAD:
The distance between the Yakima
crossbars is determined by the
accessories you wish to carry.
The Crossbar Spread Table (Fit List or
Catalog) will tell you how much crossbar
spread your accessories require.
YOU ARE NOW READY TO PROCEED TO CONTROL TOWER INSTRUCTIONS
1033031A-2/6
Replace end caps.
Engage the screw with
wrench supplied. Do not
fully tighten.
LOAD LOCATION:
For ease of loading, consider where the
most convenient placement of your load
would be before completing the
Install screw with spacer
and washer
into pad.
installation.
Align screws in Landing
Pads with plates.
Arrange Landing Pads on the tracks in the
approximate positions where the Control
Towers will be attached.
NOTE:
Do not fully tighten.
Final adjustments will
be made after Control
Tower is installed.
USE CAUTION WHEN
OPENING YOUR HATCH.
On some vehicles, hatch
interference with
accessories is unavoidable.
