ELICA Nuage Sense Montaje Y Modo De Empleo página 21

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 50
Attention! Before connecting the hood to the electrical
mains.
If you have an Elica hob:
Perform the electrical connections of the hood and Elica
hob at the same time to ensure the logical connection
between the hob and Elica hob (also refer to the
paragraph "Operation-Adjusting the parameters for
automatic operation-Sensor calibration" e "Operation-
Adjusting the parameters for automatic operation-
Logical connection between hood and Elica hob").
If you do NOT have an Elica hob:
In this case, after being connected to the mains, the hood
will try connecting to a hob.
Wait for the hob to complete the connection attempts
(approximately 5 minutes) and then disable the electronic
connection module as follows:
With the hob switched off, simultaneously press and hold
keys T1 and T2 for 10 seconds, (see Operation
paragraph), the hood at first emits a short sound signal
(beep- after approximately 5 seconds), followed by a long
sound signal (beeeep), indicating that the disabling
process is complete (LED L1 turns red for a few
seconds).
Reactivating the connection module between the
hood and Elica hob: With the hob switched off,
simultaneously press and hold keys T1 and T2 for 10
seconds, (see Operation paragraph), the hood at first
emits a short sound signal (beep- after approximately 5
seconds), followed by a long sound signal (beeeep),
indicating that the activation process is complete (LED L1
turns red for a few seconds).
Expansion wall plugs are provided to secure the hood to most
types of walls/ceilings. However, a qualified technician must
verify suitability of the materials in accordance with the type of
wall/ceiling. The wall/ceiling must be strong enough to take
the weight of the hood. Do not tile, grout or silicone this
appliance to the wall. Surface mounting only.
21
Tabla de contenido
loading

Tabla de contenido