Teac SR-L100 Manual Del Usuario página 5

For U.S.A.
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can
be determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
• Reorient or relocate the equipment
and/or the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
CAUTION
Changes or modifications
equipments not expressly approved by TEAC
CORPORATION for compliance will void the
user's warranty.
This product has been designed and
manufactured according to FDA regulations
"title 21, CFR, chapter 1, subchapter J, based
on the Radiation Control for Health and Safety
Act of 1968", and is classified as class 1 laser
product. There is not hazardous invisible laser
radiation during operation because invisible
laser radiation emitted inside of this product is
completely confined in the protective
housings.
The label required in this regulation is shown
①
.
①
(rear panel of the unit)
Optical pickup
to this
Type
Manufacturer : SAMSUNG ELECTRO-
Laser output
Wavelength
For U.S.A.
: CMS-B35
MECHANICS CO, LTD.
: Less than 0.5 mW on
the objective lens
: 760 - 800 nm
5