Proposition 65; Installation; Unpack The Machine; Add The Bar And Chain Oil - GreenWorks 20192 Manual Del Operador

CONNECT PLUG AND RECEPTACLE
WARNING
Keep the extension cord clear of the working area.Position
the cord so that it will not get caught on lumber, tools, or
other obstructions while you are working with a power tool.
Failure to do so can result in serious personal injury.
WARNING
Check extension cords before each use. If damaged replace
immediately. Never use the product with a damaged cord
since touching the damaged area could cause electrical
shock resulting in serious injury.
7

PROPOSITION 65

WARNING
This product contains a chemical known to the state of
California to cause cancer, birth defects or other
reproductive harm. Some dust created by power sanding,
sawing, grinding, drilling, and other construction activities
contains chemicals known to cause cancer, birth defects or
other reproductive harm. Some examples of these chemicals
are:
• Lead from lead-based paints;
• Crystalline silica from bricks and cement and other
masonry products;
• Arsenic and chromium from chemically treated lumber.
Your risk of exposure to these chemicals varies depending
on how often you do this type of work. To reduce your
exposure to these chemicals, work in a well-ventilated area,
and work with approved safety equipment, such as dust
masks that are specially designed to filter out microscopic
particles.
Save these instructions.
8

INSTALLATION

8.1

UNPACK THE MACHINE

WARNING
Make sure that you correctly assemble the machine before
use.
English
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
8.2

ADD THE BAR AND CHAIN OIL

Examine the amount of oil in the machine. If the oil level is
low, add the bar and chain oil as follows.
Use bar and chain oil that is only for chains and chain
oilers.
The machine comes from the factory without bar and chain
oil.
14
1. Loosen and remove the cap from the oil tank.
2. Put the oil (12) into the oil tank.
3. Monitor the oil indicator (14) to make sure that no dirt
gets into the oil tank while you add the oil.
4. Put the oil cap on.
5. Tighten the oil cap.
6. The whole oil tank will last for approximately 20- 40
minutes.
Do not use dirty, used or contaminated oil. Damage can
occur to the bar or chain.
7
WARNING
IMPORTANT
NOTE
12
IMPORTANT
EN