foam tape or cable ties (supplied)
14. Back at the front of the vehicle, with the fuse removed, attach
the 3/8" ring terminal to the vehicles
positive (+) battery terminal (Fig. 6).
Warning: Do not attempt to connect
the black power wire to the vehicle
fuse panel or any other accessory
wiring. Failure to connect directly to the
vehicle battery could cause vehicle damage and/or
trailer lighting failure.
15. At the rear of the vehicle, Strip 5/16" of insulation from the
black 12 ga. wire and connect it to the black wire using the yellow
butt connector on the converter wire.
16. Reattach the vehicles Negative (-) battery wire.
17. Place the 10 amp fuse into the fuse holder installed in step 13.
18. Test the installation using a test light or properly equipped
trailer.
19.All loose wires should be secured using cable ties or other
similar mounting devices. Return all acess panels, trays and
thresholds to their original positions.
INSTRUCCIONES DE INSTALACIÓN
Français:
1. Lire les instructions attentivement avant de
commencer.
2. Ouvrez la trappe arrière du véhicule et enlevez le filet de
cargaison, le plat de seuil, les panneaux de plancher de tronc et le
plateau de roue de secours (fig. 1).
3. Enlevez les poches accessoires placent dans les panneaux
Fig 6
