the separated vehicle connectors and press firmly together,
ensuring the locking tabs engage.
8. Locate a clean accessable ground stud near the T-Connector's
White wire. Loosen the ground bolt, insert through the ring
terminal on the T-Connector's White wire and return the bolt to its
original position, tighening appropriately.
9. Route the T-Connector ends with the Yellow wires to the left
(driver's) side of the vehicle by passing underneath the interior
trim panels and across the spare tire well. Repeat steps 6 & 7 on
the left (driver's) side using the T-Connector ends containing the
Yellow wire.
10. Raise the vehicle hood and disconnect the Negative (-) battery
cable.
11. Route the 12 gauge black wire from the battery
compartment under the vehicle along the frame (Fig.
4) to the grommet located in the vehicle floor on the
right (passenger) side near the T-Connector's black
box. Secure the wire to the vehicle using cable ties
(included).
Caution: When routing wire through metal or other sharp
surfaces, always utilize an existing grommet, provide a
grommet or insulate the wire from the hole with silicone
rubber.
12. Using a utility knife, carefully slit the grommet as indicated
(Fig. 5) making a small circle in the center of the grommet and an
outward cut from the center to the outside edge.
13. Wrap the grommet around the T-connector
harness. Replace the grommet into the vehicle,
securing the T-connector harness into place. Mount
the black box to the underside of the vehicle using
Fig 4
Fig 5
