Tabla de contenido
Idiomas disponibles
Idiomas disponibles
suitable for the machine's power. The cores
must have a diameter of at least 1.5 mm
When the extension cable is on a reel, unroll
the cable in its entirety.
•
All electrical connections e.g. extension cable,
must be of an approved waterproof type for
outdoor use and marked accordingly.
Extension cables must be threecore, one of
which is EARTH.
Immediately switch off the machine when:
•
Interruption of the mains plug, mains lead or
mains lead damage.
•
Defect switch
•
Smoke or stench of scorched isolation
specific safety rules
The USE and MAINTENANCE manual constitutes
an essential part of the cleaner equipment and
should be kept in a safe place for future reference.
If you sell the cleaner, the manual should be
handed on to the new owner.
•
Before starting the cleaner, make sure that it is
receiving water correctly. Operating the cleaner
without water could damage the seals.
•
Do not disconnect the plug by pulling on the
electrical cable.
•
If you are too far from the object you wish to
clean, do not move the cleaner nearer by
pulling on the high pressure hose; use the
handle provided.
•
In versions not equipped with TSS device, do
not operate the cleaner for more than 1-2
minutes with the gun closed as this could
damage the seals.
•
Protect the cleaner from freezing during the
winter.
•
Do not obstruct the ventilation grilles during
operation.
•
The cross-section of any extension cables
used must be proportional to their length, i.e.
the longer the extension cable, the greater the
cross-section; cables with a protection level of
"IPX5" must be used.
•
Position the cleaner AS NEAR POSSIBLE to
the water supply.
•
The packaging is easily recyclable, and must
be disposed of in compliance with the
regulations in force in the country of
installation.
•
Use the cleaner only with accessories and
replacement parts authorized by the
manufacturer. The use of original accessories
Ferm
and replacement parts will ensure safe,
.
trouble-free operation.
2
•
The cleaner must be used standing on a
secure, stable surface.
•
Avoid unintentional firing of the trigger. Do not
carry the lance/ trigger assembly with your
hand over the trigger. Always use the trigger
lock mechanism.
•
Ensure that the safety lock on the trigger is
used, when you have stopped using the
pressure washer to prevent accidental
operation. (fig 5)
safety "must nots"
•
EXPLOSION OR POISONING.
DO NOT use the cleaner with inflammable or
toxic liquids, or any products which are not
compatible with the correct operation of the
cleaner.
•
INJURY HAZARD.
DO NOT direct the water jet towards people or
animals.
•
ELECTRIC SHOCK HAZARD.
DO NOT direct the water jet towards the unit
itself, electrical parts or towards other electrical
equipment.
•
SHORT CIRCUIT HAZARD.
DO NOT use the cleaner outdoors in case of rain.
•
INJURY HAZARD.
DO NOT allow children or incompetent persons
to use the cleaner.
•
ELECTRIC SHOCK HAZARD.
DO NOT touch the plug and/or socket with wet
hands.
•
ELECTRIC SHOCK AND SHORT CIRCUIT
HAZARD.
DO NOT use the cleaner if the electrical cable
is damaged.
•
EXPLOSION HAZARD.
DO NOT use the cleaner if the high pressure
hose is damaged.
•
ACCIDENT HAZARD.
DO NOT jam the trigger in the operating
position.
•
ACCIDENT HAZARD.
Check that the data plates are affixed to the
cleaner, if not, inform your dealer. Cleaners
without plates must NOT be used as they are
unidentifiable and potentially dangerous.
•
EXPLOSION HAZARD.
DO NOT tamper with or with or alter the
calibration of the safety valve.
•
HAZARDOUS ALTERATION OF OPERATING
PERFORMANCE.
EN
5
Tabla de contenido
