NuTone LA600WH Guia Del Usuario página 3

WIRELESS CHIME INSTALLATION
Unobstructed wireless operating range: Up to 100 feet.
NOTE: Wireless pushbutton sold separately. Refer to installation
instructions included with wireless pushbutton.
Keep batteries out of the reach of children.
1. Insert three alkaline "D" batteries (not included) (E) in battery com-
partment. Make sure batteries are oriented properly. (Figure 7)
F
E
2. Obtain wireless pushbutton(s) (sold separately) and install battery
per wireless pushbutton(s) instructions.
3. Press pushbutton(s) to confirm the chime mechanism and
pushbutton(s) work properly. If the chime does not sound:
a. Confirm the code settings in the chime mechanism and wireless
pushbutton(s) are the same. Jumpers (F) installed on the num-
bered contacts on the chime mechanism must match the switches
or jumpers in the wireless pushbutton(s). (Figures 7 & 8)
WIRELESS PUSHBUTTON - EXAMPLE CODE SETTING
(Pushbutton will have jumpers or switches)
CODE SET
JUMPERS 1-6
JUMPERS REMOVED (OFF)
FROM 2, 4, 6
WIRELESS CHIME - EXAMPLE CODE SETTING
WIRELESS
JUMPERS
{
JUMPERS
{
CODE SET
SWITCHES 1-6
ON
1 2 3 4 5 6
SWITCHES 2, 4, 6
IN OFF POSITION
{
CHIME
JUMPERS REMOVED (OFF)
FROM 2, 4, 6
b. Verify proper installation of batteries in chime mechanism and
pushbutton(s).
c. Check condition of batteries in chime mechanism and
pushbutton(s). Replace if required.
4. After confirming chime operates, follow steps under section titled
"Manage Chime Notification" before proceeding to Step 5.
5. If more than one pushbutton is being installed, refer to Figure 9 to
assign doors.
FIGURE 7
6. Install the wireless pushbutton(s) at the desired door(s). Refer to
installation instructions provided with wireless pushbutton(s).
7. Place chime mechanism in desired location. Confirm operation by
pressing pushbutton(s). If the chime does not sound:
a. The chime or pushbutton(s) are mounted on or near stucco or
7 8
metal studs, the transmitter range may be reduced. Use wood
shims to raise chime or pushbutton(s) 1/4" to 1/2" from surface.
b. Concrete floors and walls may also reduce transmitter range.
Move chime away from concrete floor or wall.
c. Install chime mechanism closer to wireless pushbutton(s).
8. Remove batteries from mechanism.
9. Mount chime base to wall using screws provided (see Step 8 in "New
Wired Chime Installation" section).
10. After mounting chime base to wall, install batteries.
11. Place cover (B) over chime base (A) and press down to install.
A "click" will confirm that it is securely attached. (Figure 1).
12. Proceed to section titled: "Manage Chime Notification" .
FIGURE 8
3
WIRELESS PUSHBUTTON - ASSIGN DOORS
(Wireless pushbutton will have jumpers or switches)
FRONT
DOOR
REAR
DOOR SET
DOOR
JUMPERS
*,X,Y
FRONT
DOOR
DOOR SET
SWITCH 8
REAR
DOOR
OR
ON
1 2 3 4 5 6 7 8
SWITCH 8 ON
ON
1 2 3 4 5 6 7 8
SWITCH 8 OFF
FIGURE 9