Lenco IPD-3560 Manual De Instrucciones página 5

Description of Parts
Remote Control
.Infrared Transmitter
2.POWER / STANDBY button ----- To turn the unit on / standby
3.ALM 2 ---- Turn the alarm 2 on and off ; Set alarm time
4.PRESET / MEM button ---- Select preset radio station mode
5. / ST / MONO button----iPhone (iPod) Play / Pause function; Select FM stereo
/ mono
6.VOL / HR + / - button-----Adjust volume level up or down ; Set clock hour
7.SNOOZE/LIGHT-----Activate the snooze function ; turn LCD backlight ON / OFF
8.TREBLE button ---- Adjust Treble level
9.SLEEP button ---- Select the time duration of the sleep timer
10.ALM 1 ---- Turn the alarm 1 on and off ; Set alarm time
11.FUNC button ---- Select FM radio / iPhone (iPod) / AUX modes
12.TUN / CH / MIN + / - button----- In power off mode: Set clock minute
In radio mode: Tune the radio frequency up
down; select preset channel
In iPhone (iPod) mode: Skip tracks Forward /
Backward; perform high-speed search
13.TIME SET / TONE button ---- In power off mode: Select clock and 12/24 hour
format settings
In power on mode : Reset Bass / Treble set level
14.BASS button ---- Adjust Bass level
5.Battery Compartment
IPD3560 4lang.indd 8-9
GB
8
GB
Radio Tuner Operation
FM Antenna
Fully extend the FM Rod Antenna for the best FM radio reception.
Radio Tuning
1. Press the POWER/STANDBY button to turn on the unit.
. Press the FUNC button to select FM radio mode.
. To manually tune to desired station, repeatedly press the TUN / CH / MIN+/- button.
4. To automatically search for stations with strong signals, press and hold the
TUN / CH / MIN+/- button until the frequency digits on display begins to scan
then release the button. The tuner will stop on the first strong station signal it
finds.
Notes:
Manual tune to select weaker stations that might be by skipped during automatic
tuning.
If the automatic tuning does not stop on the exact frequency of the station, for
example, it stops on 100.9 MHz instead of 100.8 MHz, use the manual tuning
method to "fine tune" to the exact frequency of the desired station.
You may press the ST/MONO button to select FM stereo or mono receiving
mode, if necessary. In stereo mode, when a FM stereo broadcast is received
and will indicate" " in the LCD.
Radio Preset Stations
The unit allows you to store up to 0 FM stations for easy recall at any time.
Preset Stations
1. Press POWER/STANDBY button to turn on the unit.
2. Press the FUNC button to select FM radio mode.
. Tune to the radio station you want to store in memory by using theTUN / CH /
MIN+/- button.
4. Press and hold the MEM / PRESET button. The preset channel number
"C01"appears on display and flashing.
5. To select desired preset station number, press the TUN / CH / MIN+/- button.
6. To confirm preset location, press the MEM / PRESET button.
7. Repeat steps  to 6 to store other stations if necessary.
Note:
. There is a few seconds delay when programming, after this delay time, the unit
will automatically switch back to normal tuner mode.
2. You can overwrite a present station by overwriting and storing the new
frequency in its place.
Recalling the preset stations
1. Press the POWER/STANDBY button to turn on the unit.
2. Press the FUNC button to switch to the radio mode.
3. Press the MEM / PRESET button then press TUN / CH / MIN+/- button to
select the preset channel.
9
2011-3-18 11:19:36