Tabla de contenido
EMb 1200
Observe the vehicle manufacturer's safety instruc-
tions (regarding airbags, alarm systems, trip comput-
ers, vehicle immobilisers).
Prior to drilling the mounting holes, make sure that no cables and parts
of the vehicle will be damaged.
Leave ample clearance between the cables and other harnesses. Use
the enclosed cable ducts at sharp-edged holes.
Note:
We recommend that you operate the EMb 1200 in conjunction with
our EMA series amplifiers.
In any case, please observe the RMS output power of your amplifier.
It must not exceed the RMS power of the EMb 1200. Non-compliance
with this can cause damage to the product in the long term.
Connection
In order to achieve a balanced sound, we recommend that you configure
the amplifier as follows.
1. First set the volume control to minimum and the crossover control
to its middle position.
2. Now play some music on your car sound system that you are very
familiar with and that contains some low bass (e.g. pop music).
Now slowly increase the volume of the subwoofer until you feel that
the sound of the music is well balanced, i.e. the bass is neither too
weak nor overpowering.
3. Now listen to the relationship between deep male voices and the
upper bass and also take note of the relationship between the up-
per bass (kick bass) and the lower bass. The bass should ideally
Technische Daten, Specifications, Caractéristiques techniques, Dati tecnici, Technische gegevens, Tekniska data, Datos
técnicos, Dados técnicos, Tekniske data, Dane techniczne, Technické údaje, Technické údaje, Τεχνικά χαρακτηριστικά,
Teknik veriler, Tekniset tiedot, Технические характеристики, Specifications
Nominal Power
Max. Power
Sensitivity
Frequency response
Nom. Impedance
Woofer cone size
Cone material
Xmax
Dimension (WxHxD)
Weight
11
150 Watt
EIA Standard
RS 426A
600 Watt
IEC Standard 268-5
90
dB/2.83V/m
35-500
Hz
4
ohms
300
mm
Spun-Paper (SPC)
+/- 5
mm
364x335x397
mm/(")
(14.3x13.2x15.6)
10
kg
sound crisp and have a clear low bass component, and male voices
should neither sound too weak nor should they billow out. If you are
happy with the sound then you are already finished with the setup
process. If not, continue as described in points 4 and 5.
4. If male voices seem to billow out or the low bass is too weak, you
should turn the crossover control slightly towards minimum and
then resume making your adjustments as described in point 2
onwards.
5. If the bass sounds low but dirty and booming or the male voices
sound too weak, you should turn the crossover control slightly
towards maximum. Furthermore, you should set the phase control
(if present) so that the upper bass sounds as powerful as possible.
Next, resume making your adjustments as described in point 2
onwards.
installation and connecting instructions
Warning! Accident risk!
Do not mount the EMb 1200 on the rear shelf, rear
seat or at any position which ist open towards the
front. Blaupunkt recommends to install the system
in the boot.
Recycling and disposal
To dispose of the product, please use the available waste return
and collection systems.
Subject to changes!
–
+
Tabla de contenido
