KTM 75038050044 Guia De Inicio Rapido página 6

6
Attach the oil cooler to the tabs on the water cooler and fasten with two M6x12
HH collar screws (Loctite 243 + 8 Nm).
Thread the left oil line from the front left around the engine and fasten
with the banjo bolt and two copper seal rights. Do not tighten yet.
Thread in the right oil line and fasten with the banjo bolt and two copper
seal rings. Do not tighten yet.
Fasten the hose end on both lines to the oil cooler with the banjo bolts and
two copper seal rings each. Do not tighten yet.
Clip on the two spacers, align the lines and torque all banjo bolts to 15
Nm. Make sure there is enough room between the hose and the exhaust
header. Mount the tank, seat and engine sprocket cover. Allow the
engine to warm up, check the system for leaks and check the oil level;
add more oil if necessary.