7) Open up all locking clips on the sides of the front guard. (fig. 19)
8) Place the front guard into position by lining up the location plate over the top of the rear guard as shown
and push down. (fig. 20)
9) Secure the two guards by closing the clips over the outer rim. (fig. 21)
10) Then using the small nut and bolt, fasten the two guards together at the bottom of the guards. (fig. 22)
OPERATING INSTRUCTIONS
1.
Plug the power cord into a suitable socket.
2.
Switch on the fan by using the speed switch on the motor housing. "0" = off, "1" = low speed, "2" = medium
speed, "3" = high speed.
3.
Tilting angles: You can loosen the big and small black knobs on the motor bracket to adjust the fan to your
preferred elevation. Then fasten the elevation by tightening the knobs.
4.
Oscillation: to make the fan head oscillate, push down the oscillation knob on the top of the motor. To stop
the fan head from oscillating, pull up the oscillation knob.
CLEANING
1.
Before servicing the fan and after each occasion of use, switch off the appliance and unplug the mains cable
from the socket.
2.
Never immerse the appliance in water (danger of short-circuit). To clean the appliance, only wipe it down
with a damp cloth and dry it carefully. Always take out the mains plug first.
3.
Take care that excessive dust does not build up in the air-intake and air-outlet grille, and clean it occasionally
using a dry brush or vacuum cleaner.
TECHNICAL DATA
Operating voltage: 220-240V ~ 50/60Hz
Power consumption: 60W
Recycling – European Directive 2012/19/EU
This marking indicates that this product should not be disposed with other household wastes. To
prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle
it responsibly to promote the sustainable reuse of material resources. To return your used device,
please use the return and collection systems or contact the retailer where the product was purchased. They can
take this product for environmental safe recycling.
- 42 -