ProKlima FN-114509.1 Manual De Instrucciones página 42

4) Line up the holes and fit the bolt all the way through. (fig. 4)
5) Fit the nut to the protruding end of the bolt and using a spanner and a screw driver, tighten the nut. (fig. 5)
6) Repeat for the other two legs.
7) To open out the legs, grasp a leg whilst holding the hub firmly and swing the leg out until it locks in place.
(fig. 6)
8) Adujust the height adjustment pipe to your desired height and tighten the fastening knob. (fig. 7)
CAUTION: Take care not to pinch your hand or any other object in the hinged components.
2. Motor housing assembly
1) Stand the Tripod on the floor.
2) Remove the big black knob and mounting bolt from the top of the adjustment pipe. Unscrew the knob and
pull the bolt straight out. (fig. 8)
3) Loosen the small screw from the bracket on the motor housing. (fig. 9)
4) Find the hole in the adjustment pipe which is pointed out by the arrow. (fig. 10)
5) Sit Motor housing on top of the adjustment pipe ensuring the small screw on the motor bracket lines up
with the hole in the pipe, then tighten the screw all the way in. (fig. 11)
6) Insert the mounting bolt through the bracket and the pipe. Note: the Square section under the head of the
bolt must be aligned with the square hole in the bracket (fig. 12)
7) Refit the big black knob to the mounting bolt. (fig. 13)
8) Screw in the small black knob but do not tighten. (fig. 14)
9) Adjust the tilt angle of the fan head to your desired position and then fully tighten both the small and big
black knobs.
3. Fan guards and blade assembly
1) To assemble the fan guards and blade, first remove the 4 rear guard fastening screws from the motor. (fig.
15)
2) Fit the rear guard into position (with the handle on the back of the guard at the top) and refit the 4 screws
and tighten. (fig. 16)
3) Remove the protective plastic sleeve from the motor spindle shaft and discard.
4) Next, rotate the motor spindle until the area with the "flat" surface is facing up.
5) Slide the fan blade onto the spindle ensuring the screw is lined up with the "flat" surface on the spindle as
shown. (fig. 17)
6) Push on until the end of the spindle is flush with the end of the fan blade hole, then tighten the screw. (fig.
18)
- 41 -