Tabla de contenido
EN
14
Maintenance
To reduce the risk of a fi re, ensure that the lawnmower and in particular the engine, exhaust muffl er, battery
and also the location of spare fuel storage are free of grass, leaves or excessive amounts of lubricant.
Regularly inspect the condition of the defl ector and the grass catcher; replace if damaged.
Drain the fuel in a well ventilated area when the engine has cooled down.
When removing or installing the mowing blade, use thick work gloves.
It is necessary to check the balance of the mowing blade every time that it is sharpened.
ATTENTION: Before carrying out maintenance or repairs, stop the engine and disconnect the spark plug.
Regularly inspect the lawnmower and ensure that all grass deposits are removed from the underside of the
chassis.
Regularly lubricate the axle of the chassis and the bearings using a suitable lubricant.
Regularly inspect the condition of the blades because they have a signifi cant effect on the performance of the
lawnmower. Blades should always be sharp and balanced.
In regular intervals, check that all nuts and bolts are tightened. Nuts and bolts that are worn out or incorrectly
tightened may cause serious damage to the engine or the frame.
If the blade strongly impacts an obstacle, stop the lawnmower and take it to an authorised service centre.
BLADE: the blade is made from pressed steel. To achieve the best possible mowing results, regularly sharpen
the blades, approximately after every 25 hours of operation. Check that the blade is always correctly
balanced. To do this, insert a steel axle (with a diameter of 2-3 mm) into the middle hole. If it is correctly
levelled, the axis will remain in the horizontal position.
If the blade does not remain in the horizontal position, replace it.
When removing the blade, screw out the bolt, check the load bearing part of the blade. If the parts are worn
out or damaged, replace them.
ATTENTION: Always use only original spare parts. Poor quality spare parts may cause serious damage to
the lawnmower and create a safety hazard.
SERVICE
In the event that after purchasing the product you fi nd any kind of defect, contact the service department.
When using the product, follow the instructions contained in the included user's manual.
A complaint will not be accepted if you modifi ed the product or if you did not follow the instructions in the
user's manual.
WARRANTY DOES NOT COVER
Normal wear and tear of operating parts of the machine as a result of its use
Servicing tasks related to standard maintenance of the machine (e.g. cleaning, lubrication, tuning, etc.).
Defects caused by external effects (e.g. climatic conditions, dustiness, inappropriate use, etc.)
Mechanical damage resulting from the machine being dropped, impact, etc.
Damages resulting from unprofessional handling, overloading, use of incorrect parts, inappropriate tools, etc.
On returned products that were not properly protected against mechanical damage during transport, the risk
of potential damage is borne exclusively by the owner.
FZR 4005 BH
Tabla de contenido
