Cleaning And Maintenance - Domo DO226SV Manual De Instrucciones

CLEANING AND MAINTENANCE

CLEANING THE MACHINE
Clean the machine with a slightly moist soft cloth. Dry the machine off well. Never submerge the machine
in water!
THE DUST CONTAINER AND THE FILTERS
Never exceed the maximum indicator on the dust container.
1. Empty the dust container by pressing the release button. The dust container falls open and you can
then remove the coarse dirt.
2. Close the dust container and turn it to the left to detach it from the appliance.
3. Turn the filter to the left to remove it from the motor compartment. Disconnect Part A from Part B
for more accurate cleaning.
4. Loosen the release of the filter at the top of the appliance to remove the HEPA filter.
1
5. Clean all these parts carefully with water. Pay attention that the parts are completely dry before
using the appliance again.
6. Replace all the parts step by step in the appliance before using it again.
We advise replacing the filters regularly to ensure an optimal operation of the machine. Dirty filters
will reduce the suction power drastically. After every cleaning, clean the dust reservoir and the filters to
extend the life span of your machine.
THE FLOOR BRUSH
The appliance has a special floor brush which allows dirt and dust to be collected even better. Clean them
according to the following steps:
1. Remove the floor nozzle from the upright vacuum cleaner. Press the release button at the back of
the floor nozzle and remove it from the machine.
2. Loosen the cover on the right side of the floor brush. Pay attention to the lock symbol. Once you
have opened the lock, you can release the cover by pulling on it.
3. Remove the rotating floor brush from the floor nozzle.
4. Remove hairs and other dirt that have wrapped around the floor brush. If you do not clean the floor
brush regularly, it will become damaged and your machine will become unusable.
5. The rotating floor brush may be rinsed off under running water. Make sure that it is completely dry
before using it.
6. Place the floor brush back into the floor nozzle when it is clean.
7. Replace the cover on the floor nozzle and tighten it back into place. Pay attention to the lock
symbol.
8. Push the nozzle back onto the stick. The machine is now again ready for use.
Stuck hairs can damage the machine or your floor. Always remove the hairs stuck on the brushes.
32
DO226SV
2
3 4
A
B