Tabla de contenido
Idiomas disponibles
Idiomas disponibles
To disassemble the appliance, remove the various parts step by step: the floor brush, the crevice tool, the
dust brush and the tube. To do this, press the release button and remove the relevant part by pulling it.
WALL MOUNT
Please follow below instructions to fix the wall mount:
1.
Drill 3 holes in the wall corresponding to the attachment points
of the wall mount.
2.
Insert the supplied plugs into the wall.
3.
Fix the wall mount using the supplied screws.
4.
To store the device, simply hang it on the wall mount.
USE
·
Press the on-off switch on the handle to turn the machine on. The battery indicator illuminates to
indicate the battery level. When the battery is low, the indicator will blink on and off to indicate that
the device needs to be charged.
·
When you switch on the machine, the rotating floor brush at the bottom of the floor nozzle will begin
to turn. This will cause the
collected in the dust reservoir.
·
The machine is equipped with a safety which will ensure that the machine shuts itself off if, for
example, objects which are too large are sucked up, or if
This is for personal safety and to protect the motor. To reverse the floor brush, press the on/off button
again.
·
For the best results, clean the dust reservoir and the filters after each use. This is better for the suction
power and the life span of the machine. Make sure that the dust in the dust reservoir does not exceed
the maximum level.
ACCESSOIRES
You can use the following accessories on the hand-held vacuum cleaner (by
removing the shaft) or secure them on the shaft:
1.
Dust brush: for
furniture, bookshelves, curtains and hard to clean
surfaces.
2.
Crevice
vacuum
cleaner: for crevices, corners, stairs, keyboards,...
www.domo-elektro.be
3
dirt in the opening to be shifted and thereby vacuumed up. The dirt will be
2
4
fingers become tangled in the floor brush.
1
3
2
2
31
DO226SV
Tabla de contenido
