Maintenance/Repair; Charging The Battery; Battery Use - Bartec Mobile X Guia De Inicio Rapido

Do not attempt to open or repair the device. Improper repair or opening can lead to
the destruction of the device, fire or explosion. Only authorized personnel are allowed
to repair the device.
Only use accessories approved by BARTEC GmbH.
Power off the device in hospitals or other places where the use of mobile phones
is prohibited. This device may affect proper work of medical equipment, such
as pacemakers, so always keep a distance of at least 15 cm between the device
and these devices.
Observe all corresponding laws that are in force in the respective countries regarding
the use of devices while operating a vehicle.
Please power off the device and disconnect the charging cable before cleaning
the device.
Do not use any chemical cleaning agents to clean the device or the charger.
Use a damp and anti-static soft cloth for cleaning.
Do not discard old and abandoned lithium batteries into the trash, send them to
designated waste disposal locations.
The user alone is responsible for any and all damages and liabilities caused by
malware downloaded when using the network or other data-exchange functions of
the device. BARTEC GmbH cannot be held responsible for any of those claims.
WARNING
BARTEC GmbH will not assume any liability for damages caused by disregarding any
of these advices or by any inappropriate use of the device.

MAINTENANCE/REPAIR

The device itself has no user-serviceable parts. It is recommended to perform
inspections according to the safety regulations and advises.
If there is a problem with the device, please contact your vendor or consult the service
center. If your device is in need of repair, you can either contact the service center or
your vendor.
BATTERY
The battery is not fully charged when the device is purchased, but it contains enough
energy to power on the device. To obtain best battery performance and battery life,
let the battery discharge completely before charging it completely for the first three
charging cycles.

CHARGING THE BATTERY

Connect the i.safe PROTECTOR to the USB port on the device. Then connect
the i.safe PROTECTOR to the power adapter. After charging, please disconnect
the i.safe PROTECTOR from the power adapter.

BATTERY USE

In actual use the run time of the device varies with the network status, working
environment and usage.
6