Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Always wear SAFETY GLASSES
when installing hitch
Authorized Drawbar Kit:
3593 (Sold Separately)
Drawbar must be used in the
RISE position only.
Hole to
be drilled
Access hole
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged
should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. This product complies with safety specifications and requirements for
connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2021 Horizon Global™ Corp - Printed in Mexico
Installation Instructions
PART NUMBERS: 24999, 77999, CQT24999
Conical washer
teeth side
against hitch
Note: Fasteners typical
Hole to
both sides
be drilled
Figure 1
Figure 2
①
②
③
①
④
②
⑤
Access hole
③
④
11" [279.4]
2" [50.8]
4" [101.6]
Sheet 3 of 33
24999NP
Fastener Kit: 24999F
Qty. (2)
Carriage bolt
7/16"-14 x 1.75, GR5
Qty. (2)
Spacer
.875 x 2.00 x .109
Qty. (2)
Conical washer
7/16"
Qty. (2)
Hex nut
7/16" -14 GR2
Qty. (2)
Pull wire
7/16"
⑤
Kink pullwire to keep
spacer independent of bolt
C L
2.5"
[63.5]
Figure 3
1-08-21
Rev. A
Tabla de contenido
