Philips Supervapor 40 Manual Del Usuario página 5

Table
Label with
ironing
instructions
B
C
D
Z
article has been made of, find a spot which will
be invisible when wearing or using the article to
try out the ironing temperature. (Always start at
a low temperature and increase to one which
gives the required results.)
• Pure woollen fabrics (100% wool) may be
pressed with the iron set to a steam position.
It is recommended to apply shot-of-steam and
use a dry pressing cloth.
When steam-ironing woollen fabrics, shining of
the fabric may occur. This can be prevented by
turning the article inside out and ironing the
inside.
• Velvet and other textures which rapidly acquire
shiny spots should be ironed in one direction
only (with the nap), applying only light pressure.
Always keep the iron moving.
• Iron the reverse side of synthetic materials and
silk to prevent shining spots. When ironing
coloured silk, it is not advisable to use steam as
this may cause stains.
Kind of Temperature
textile dial
Synthetic
e.g. acetate,
acrylic,
viscose,
polyamide,
polyester.
Silk
Wool
Cotton
MAX Linen
Please note: This article cannot be ironed!
Steam-
ironing
MIN
|
|
–
1
|
|
A
|
2
A
MIN
|
3
MIN
Filling with water
steam and steam-spray)
- Position the steam
tank on a stable flat
surface and unscrew
the cap of the steam
tank (D) by turning
anti-clockwise.
- Fill the steam tank
with water
(max. 0.9 litre)
(fig. 2).
• You can use
tapwater. However, if the water is very hard
(hardness higher than 17 °DH / 21
is advisable to use distilled water.
• Never use vinegar, descaling agents or other
chemicals.
5
Shot of
steam
–
MAX
MAX
(for steam-ironing, shot-of-
2
Jet of steam
1 ⁄ °Clarke), it
4