Idiomas disponibles
Idiomas disponibles
2.4
Ambient Conditions for Storage and Transport
For storage and transport the following specifications to ambient conditions apply:
• Ambient temperature -20 – +60 ºC [-4 – +140 ºF].
• Maximum relative humidity 80 %.
2.5
Hazard and Warning Information
2.5.1 General Information
► If the device is not used in compliance with the supplied instructions, the safety of the device
can no longer be guaranteed.
► The device may only be operated using a mains cable with the country-specific plug system.
Any necessary alterations must be carried out by a qualified electrician.
► The device may only be operated if the information on the identification plate conforms to the
specifications of your local mains power supply.
► The mains plug must be easily accessible.
► It is the responsibility of the operator that national regulations during operation and regarding
a repeated safety inspection of electrical equipment are complied with. For Germany these are
the regulation 3 by DGUV (German Statutory Accident Insurance) in relation with VDE 0701-0702
(Association for Electrical & Electronic Technology).
► Disconnect the device from the mains before carrying out work on the electrical parts.
► Check connection cables (such as power supply cords), tubes and housing (i.e. the key-pad)
regularly for damage (i.e. kinks, cracks and porosity) or signs of ageing.
Devices with damaged connection cables, tubes or housing parts or other defects must not be
operated!
► Defective devices must be put out of service immediately. Remove the mains plug and ensure
the device is not used. Send the device for repair!
► Only operate the device under supervision.
► The use of unauthorized accessories may be an impediment to the safety of the device.
Use spare parts and accessories supplied by Renfert only.
► Observe the accident prevention regulations by the trade association!
► Information on REACH and SVHC is available on our website www.renfert.com, in the Support
area.
2.5.2 Specific Information
► Do not look directly into the lamps!
► Do not cover lights while in operation as this poses a fire hazard!
► Hot surface. The housing on the LED light fitting becomes hot when in use.
2.6
Authorized Persons
Operation and maintenance of the device may only be performed by qualified personnel.
Any repairs not specifically described in these operating instructions may only be carried out by a
qualified electrician.
2.7
Disclaimer
Renfert GmbH shall be absolved from all claims for damages or warranty if:
► The product is employed for any purposes other than those specified in the operating instruc-
tions.
► The product is altered in any way other than those alterations described in the operating in-
structions.
► The product is not repaired by an authorized facility or if non-original Renfert parts are imple-
mented.
► The product continues to be used despite obvious safety faults or damage.
► The product is subjected to mechanical impacts or is dropped.
- 3 -
EN
Capítulos
