Troubleshooting; Technical Data; Warranty; Disposal Information - Renfert 2200 5000 Instrucciones De Uso Originales

7. Troubleshooting

EN
Error
None of the lamps come
on.
The left lamp does not
light up.
Light not powerful
enough.

8. Technical Data

Nominal voltage:
Mains frequency:
Mains adapter power consumption:
LED light fitting operating voltage:
LED light fitting current consumption:
Dimensions (Width x Height x Depth):
Weight (excl. mains adapter), approx.:

9. Warranty

Provided the unit is properly used, Renfert warrants all components for 3 years.
Warranty claims may only be made upon presentation of the original sales receipt from the authorized
dealer.
The warranty is voided in the case of improper use; failure to observe the operating, cleaning, mainte-
nance and connection instructions; in case of independent repairs or repairs by unauthorized person-
nel; if spare parts from other manufacturers are employed, or in case of unusual influences or influenc-
es not in compliance with the utilization instructions.
Warranty service shall not extend the original warranty.

10. Disposal Information

10.1 Disposing of the Unit

The unit must be disposed of by an authorized recycling operation. The selected firm must be informed
of all possible health hazardous residues in the unit.

10.1.1 Disposal Instructions for countries in the EU

To conserve and protect the environment, prevent environmental pollution and improve the recycling of
raw materials, the European Commission adopted a directive that requires the manufacturer to accept
the return of electrical and electronic units for proper disposal or recycling.
Within the European Union, units with this symbol should not therefore be disposed of in un-
sorted domestic waste.
Please contact your local authorities for more information on proper disposal.
Possible Cause
• Incorrect connection.
• Defective mains adapter.
• LED light fitting defective.
• Connection cable damaged.
• It has been switched over to
dimmer function.
• Dirt on glass guards.
- 6 -
Corrective Action
• Check leads and plug connections.
• Order mains adapter from spare parts list.
• Send LED light fitting in for repair.
• Send LED light fitting in for repair.
• Switch LED lights off and then back on again
(cf. also section 5).
• Switch off LED light and allow to cool down.
Clean glass guards.
100 - 240 V
50 / 60 Hz
16 W
12 VDC
1,2 A
162 x 34 x 82 mm
[6.38 x 1.34 x 3.25 inch]
250 g
[0.55 lbs]
Subject to change