Idiomas disponibles
Idiomas disponibles
Installation and removal of cable protection parts
Installation and removal of cable
LED indicators and beeper
Status
Power on
Power down
State of operation and standby Only Red LED on(always) -- For 1D mode,
Good read
Scan Setting Codes
Left Key
Right Key
Poke into the small hole to
release the cable
Response
LED on(always),Two short beep.
LED go out.
default setting.
Green LED on also(always) -- For 2D mode.
Red/Green LED flashes one time.
One short beep.
Successfully setup, buzzer sounds twice.
Switch for 1D Mode and 2D Mode, 3 short
beep when press for switching.
Each click of this button will change the
sound of a beep.
7
