Quick Start - HURAKAN HKN-HBH850 PRO Introducción

QUICK START

1. Connect the power supply.
2. Put the switch in the ON position.
3. Put the required quantity of product into the blender jar and place it on the damping pad.
Make sure that the jar is properly placed and the cover is tightly fixed in its upper part.
4. Manual modes: select the required mode — HIGH, MED, LOW — for the continued opera-
tion of the equipment with the pre-set blade rotation speed. PULSE mode is turned on with
the button pressed and held; it corresponds to the maximal rotation speed of the blade.
5. Automatic modes: press 35'', 60'' or 90'' button to select the blender operation for 35, 60
or 90 seconds with subsequent stop. Automatic modes have the variable rotation speed and
preset operation time. These modes are ideal for fast preparation of smoothies or ice drinks
being the most popular.
6. In the course of the blender operation, the red LED light is on, and the processing cycle
completes with a long sound signal.
TIP: to stop or interrupt any cycle, it is enough to press any button.
OPERATION INSTRUCTIONS
1. Use the equipment on a flat horizontal surface.
2. Never turn on the blender while its jar is empty.
3. The jar may not be removed while the blender is operating.
4. Never turn on the blender while the jar is not in place.
5. Make sure the damping pad is dry and clean at all times. Moisture drops on the pad surface
can penetrate to the equipment, which will result in its failure!
6. Before turning on the equipment, make sure the jar is properly installed on the equipment
and is well coupled with the junction area.
Always add a bit of water when grinding ice.
CLEANING
Attention: power off the equipment prior to cleaning!
1. Pour a small quantity of warm water with detergent into the blender jar. Close the cover
tightly and turn the blender on for about 10 seconds. Empty the jar, rinse it with clean water
and leave it upside down to dry.
Do not clean the jar inside manually if the blade has not been removed.
2. To remove the blade, turn the clamping ring on the jar bottom clockwise with the special
key.
3. Use damp cloth to clean the blender base. Never immerse the motor unit into water!
4. To extend the service life of the blade assembly, do not immerse the jar into water and do
not leave it with liquids for a long time. This will prevent corrosion of the bearing by minimizing
the time of its contact with water.
TROUBLESHOOTING
Attention: before inspecting the equipment and identifying its faults, disconnect it from the
power mains!
EN
9