Electrical Safety - Stanley FATMAX FMC627 Manual Del Usuario

:
f
p
Vibration
Labels on tool
Additional safety instructions for batteries and
chargers
Batteries
Chargers
The declared vibration emission values stated in the technical
data and the declaration of conformity have been measured in
accordance with a standard test method provided by
EN 60745 and may be used for comparing one tool with
another. The declared vibration emission value may also be
used in a preliminary assessment of exposure.
Warning! The vibration emission value during actual use of
the power tool can differ from the declared value depending
on the ways in which the tool is used. The vibration level may
increase above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons regularly
using power tools in employment, an estimation of vibration
exposure should consider, the actual conditions of use and the
way the tool is used, including taking account of all parts of
the operating cycle such as the times when the tool is
switched off and when it is running idle in addition to the
trigger time.
The following pictograms are shown on the tool along with the
date code:
Warning! To reduce the risk of injury, the user must
read the instruction manual.
Wear ear protectors with impact drills. Exposure to
noise can cause hearing loss
Never attempt to open for any reason.
Do not expose the battery to water.
Do not store in locations where the temperature may
exceed 40 °C.
Charge only at ambient temperatures between 10 °C and
40 °C.
Charge only using the charger provided with the tool.
When disposing of batteries, follow the instructions given
in the section "Protecting the environment".
Do not attempt to charge damaged batteries.
Use your Stanley Fat Max charger only to charge the
battery in the tool with which it was supplied.
u
u
u
u
u
u
u
$
+
#
Features
Assembly

Electrical safety

Fig. A
(Original instructions)
damage.
Never attempt to charge non-rechargeable batteries.
Have defective cords replaced immediately.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
The charger is intended for indoor use only.
Read the instruction manual before use.
Your charger is double insulated; therefore no earth
wire is required. Always check that the mains
voltage corresponds to the voltage on the rating
plate. Never attempt to replace the charger unit with
a regular mains plug.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Stanley Fat Max Service
Centre in order to avoid a hazard.
This tool includes some or all of the following features.
1. Variable speed switch
2. Forward/reverse slider
4. Chuck
5. Mode select collar
6. Speed selector
7. Magnetic bit holder
8. Battery
9. LED work light
10. Belt clip
11. State of charge indicator
12. Bit storage clip
13. Charger
14. Charge indicator
Warning! Before assembly, remove the battery from the tool.
tool. Slide the battery into the receptacle and push until
the battery snaps into place.
To remove the battery, push the release button (15) while
at the same time pulling the battery out of the receptacle.
Other batteries could burst, causing personal injury and
u
u
u
u
u
u
3. Torque adjustment collar
Fitting and removing the battery (fig. B)
To fit the battery (8), line it up with the receptacle on the
u
u
ENGLISH
5