DMG Honigum Pro Instrucciones De Empleo página 13

4. Remove the impression from the mouth
once the setting time has ended, see
„Removal".
Final impression
The individual times for the materials used
are provided in the "Technical data" section.
Follow the corresponding instructions for use!
Note: Do not allow more than 30 minutes to
pass between completion of the pre-impression
and the final impression and do not use alcohol
for cleaning during this time, as it is otherwise
not possible to guarantee a secure bond between
the two impression materials.
1. Cut generous relief channels into the pre-
impression and remove any imperfections.
2. After testing repositioning, rinse the
impression thoroughly with water and then
dry.
3. Apply Honigum Pro-Light Scan around the
preparation and on the pre-impression.
14
4. Position the filled impression tray slowly and
gently in the mouth within the working time,
initially exerting brief pressure.
5. Remove the impression from the mouth
once the setting time has ended, see
„Removal".
Removal
1. In the area where the teeth have been
prepared, remove the impression parallel to
the longitudinal axis of the teeth.
2. After removal, cut the impression free as far
as possible in order to facilitate optimum
scanner access to the relevant areas."
3. Then proceed as described under „Cleaning
and disinfection of the final impression".
Cleaning and disinfection of the final
impression
Only disinfect the final impression using dipping
solutions.