Zolia DOG TRAINING 200 Manual De Instrucciones página 5

Power saving :
The collar receiver will TURN OFF if it is unused for 4 minutes.
Any movement will activate the collar receiver into STANDBY MODE, the transmitter will go into
STANDBY MODE if there is no operation after 20 seconds and turn off after 2 minutes.
Prepare the remote transmitter :
Charge the remote transmitter
1- Connect the charger connector to the charging jack
2- Plug the charger into a standard outlet
3- The red light on the transmitter will be lighted
4- Charge the transmitter at least 6 hours for the first charger.
5- After fully charged, the red led will be turned off automatically.
Low batterie indicator : the symbol​
How to use the transmitter :
1- To turn on/off the transmitter, hold the transmitter for 5 seconds.
2- Set to the different modes by pressing the mode button – the LCD images will change
3- press the up and down buttons on right hand side to set level.
4- Choose the different channels for 1 or 2 receivers.
5- The transmitter will go into STANDBY MODE if not operated for 20 seconds and will TURN OFF if
not operated for 2 minutes.
6- in STANDBY MODE, press any button (except LED button) to wake it up.
Prepare the collar receiver:Charge the collar receiver
1- Connect the charger connector to the charging jack.
2- Plug the charger into a standard outlet.
3- the red LED light inside the collar receiver will be lighted.
4- Charge the collar receiver at least 6 hours for the first charge
5- After fully charged, the red LED light will be turned off
automatically.
6- When charging is completed, replace the rubber cover.
Low battery indicator:​ the collar receiver will keep beeping for 2
minutes unless it gets charged.
Connect the transmitter with the collar receiver :
1- Turn on the transmitter and choose 1 or 2 channels to encode.
2- Lift the reset part of rubber cover in the collar receiver.
3- With a pen or paper clip, press the reset button inside the collar receiver.
4- After a beep from the collar receiver, press the LAUNCH button on transmitter immediately.
5- The collar receiver will beep – it is now encoded to the transmitter.
6- after encoded is completed, replace the rubber cover back.
​
w ill show up on the right down side of LCD screen.