Uline H-3616 Manual Del Usuario página 4

5. Attach the sill (8) to the sides. Place nuts loosely on
each of the studs and slide the ends of the sill into
the slots on both sides of the unit. Then, securely
tighten with nuts. (See Figure 5)
8
Slide studs into the slots
located near the bottom
of each side panel.
6. Place a shelf (5) into the lowest shelf supports in the
back. The front of the bottom shelf will rest on the sill.
(See Figure 6)
5
8
7. Using two people, set unit upright and tighten all
nuts and bolts. Insert the other shelf into the top
position of the shelf supports. Be sure the shelf edge
with no slots faces the cabinet front. The slots on the
other three sides fit over the shelf supports on the
cabinet walls, which hold the shelf in place.
NOTE: To ease shelf installation, have second
person apply slight pressure to the back panels
from behind the cabinet, while other person
installs shelves.
PAGE 4 OF 15
ASSEMBLY CONTINUED
8. Attach a coat rod bracket (13) beneath the left side
of the cabinet shelf by inserting one bolt through the
hole in the left edge of the shelf. Secure with a nut.
Attach the right bracket in the same way. Slide the
coat rod (12) through the holes in the brackets.
(See Figure 7)
Figure 5
Figure 7
9. Attach the left door (6) to the unit. Place the door on
the hinges, align the holes, and drive the four hinge
pins (11) into place. (See Figure 8)
Figure 6
10. Repeat step 9 for the right door (7).
11. Adjust the levelers underneath the front of the unit to
ensure the cabinet is leveled.
13
12
11
6
NOTE: If having issues with doors aligning, it
may be due to cabinet not sitting level. Use
included nut driver to adjust leveling feet in
bottom front two corners. Nut driver should
insert through inside of cabinet down into feet
and adjust as needed.
NOTE: The doors will not align properly if the
cabinet is not leveled.
Figure 8
7
0321 IH-3616