Idiomas disponibles
Idiomas disponibles
15) Fit the upper striker as follows:
a) place the striker against the frame profile and bring it near the spring latch
b) make sure the striker is in contact with the spring latch and that the door opens without interfering with the
striker when the bar is pressed. In case of interference or no contact, reposition the striker, using the shims
supplied in the pack, until finding the correct position
c) make 2 Ø3,2 side holes using the striker as a template
d) secure the striker and possible shims with 2 Ø3,9 self-tapping screws supplied with the product
e) adjust the position of the striker to obtain correct compression of the door seals
f) make the Ø3,2 middle hole (using the striker as a template) and secure with the third Ø3,9 self-tapping screw
g) press the bar all the way and check correct opening of the door.
16) Fit the upper striker as follows:
a) place the striker on the frame profile and bring it near the spring latch
b) make sure the striker is in contact with the spring latch and that the door opens without interfering with
the striker when the bar is pressed. In case of interference or no contact, reposition the striker, using the
shims supplied in the pack, until finding the correct position
c) make 2 Ø4,2÷Ø4,5 side holes for the fixing screws.
d) secure the striker and possible shims with the 2 M4 screws supplied with the product.
e) press the bar all the way and check correct opening of the door.
17) Fit the floor striker as follows:
a) hold the floor striker in place against the door in line with the bottom spring latch and mark the position of the
holes
b) make two Ø6 mm holes on the floor and insert the two plugs (supplied) for the striker
c) fix the striker by tightening the two screws
d) press the bar, open the door and check opening
18) Fit the floor striker as follows:
a) hold the floor striker in place against the door in line with the bottom spring latch and mark the position of the
holes
b) make two Ø6 mm holes on the floor and insert the two plugs (supplied) for the striker
c) fix the striker by tightening the two screws
d) press the bar, open the door and check opening
If, with the strikers fitted, the vertical position of the spring latches has to be adjusted, loosen the fixing screws, remove
screw F, adjust the position of the spring latches, tighten the screws and carry out final adjustment as already described in
point 14.
19) Rod cover
Cut the rod covers to the following dimensions on the side opposite that with the groove:
- length of top rod cover
- length of bottom rod cover
N.B.
If the emergency opener has been installed at the recommended height from the floor 1115 mm, the bottom rod cover will
not need shortening.
20) Position the rod covers and secure them in place with the emergency opener cover and the spring latch covers.
ISTRUZIONI - INSTRUCTIONS - INSTRUCTIONS - INSTRUCCIONES
X - 2
Y - 2
- 12/32 -
I0327001/03-2018
