Idiomas disponibles
Idiomas disponibles
INSTALLATION
3) To fit the spring latches on the AP001-PUSH BAR emergency openers, top/bottom and modular version, carry out the
steps given in the emergency opener instruction sheet up to "5d".
To fit the spring latches on the AP002-TOUCH BAR emergency openers, top/bottom and modular version, carry out the
steps given in the emergency opener instruction sheet up to "5c".
4) To fit the spring latches on the AP001 F-PUSH BAR emergency openers, top/bottom and modular version, carry
out the steps given in the emergency opener instruction sheet up to "5d".
To fit the spring latches on the AP002 F-TOUCH BAR emergency openers, top/bottom and modular version, carry
out the steps given in the emergency opener instruction sheet up to "5c".
The main boxes of the AP001 and AP002 series emergency openers (also in fire door version) are the same for overall
dimensions and positioning on the door with respect to the axis Vp, therefore the instructions for establishing the length
and fitting the connection rods and rod covers are the same for all the types of emergency openers.
Fig.2
5) Mark the position of the fixing holes for the top and bottom spring latches. Drill the four Ø3 holes.
If the profile configuration makes it impossible to drill 1 of the 4 Ø3 screw holes, just 3 holes will be sufficient. Three
screws are enough to hold the spring latches in place securely and rigidly.
6) Remove the templates and fit the top and bottom spring latches to the door using the screws provided.
7) Measure distances X and Y (see fig.3).
8) Fix the plastic holder plate for the top rod cover to the door at the half way point of distance X along the VP/VS line
using the countersunk self-tapping screw (see fig.3).
9) Cut the threaded rods to the following dimensions:
- top trod length:
- bottom rod length:
N.B.
If the emergency opener has been installed at the recommended height of 1115 mm above floor level, the bottom rod fund
should not need shortening.
10) Fit two rubber rings A provided in the kit to both rods (top and bottom). Position the rings at about 1/3 of the rod
length (see fig. 4).
11) Screw the nut C on to one end of the threaded rods B and then screw on the bushes D. Tighten the nuts C firmly
against the bushes (see fig. 4).
12) Screw the threaded rods on the bushes E fixed to the top and bottom spring latches.
13) Secure bush D to the main mechanism with screw F.
14) Check correct adjustment of the top spring latch. On pressing the bar all the way, the spring latch must be on its
own stop. If necessary, remove screw F, adjust the threaded rod until bringing the spring latch on its own stop and
retighten screw F. Carry out the same check to also adjust the bottom spring latch.
ISTRUZIONI - INSTRUCTIONS - INSTRUCTIONS - INSTRUCCIONES
X + 15
Y + 15
- 10/32 -
I0327001/03-2018
