Care And Cleaning; Control Panel - Haier QDT125 Serie Manual Del Propietário

CARE AND CLEANING

CONTROL PANEL

To clean the control panel, use a lightly dampened cloth.
Then dry thoroughly.
EXTERIOR DOOR PANEL
Before cleaning the front panel, make sure you know what type
of panel you have. Refer to the last two letters of your model
number. You can locate your model number on the left-hand tub wall
just inside the door. If your model number ends with BB or WW then
you have a painted door panel. If your model number ends with SS,
then you have a Stainless Steel door panel.
Follow the instructions below for cleaning the door panel for
your specific model.
Painted Door Panel (model numbers ending in BB–black
or WW–white)
Use a clean, soft, lightly dampened cloth, then dry thoroughly.
Do not use scouring pads or powered cleaners because these
products can scratch the finish.
Stainless Steel Door Panel (model numbers ending in SS)
For cleaning rust and tarnish, cleaners with oxalic acid such
as Bar Keepers Friend Soft Cleanser™ will remove rust,
tarnish and small blemishes. Use only a liquid cleanser free
of grit and rub in the direction of the brush lines with a damp
soft sponge. Do not use appliance wax or polish on the
stainless steel.
For other blemishes and marks, use Stainless Steel Magic or
a similar product using a clean soft cloth. Do not use appliance
wax, polish, bleach or products containing chlorine on Stainless
Steel. You can order Stainless Steel Magic # WX10X29 through
Haier Appliances Parts by calling 877-337-3639. In Canada, call
800-661-1616.
DISHWASHER INTERIOR
To clean and de-odorize your dishwasher, use citric acid or
Finish Dishwasher Cleaner, a detergent additive. Finish
®
Dishwasher Cleaner will break up mineral deposits, and
remove hard water film and stains.
You can order citric acid Haier Appliances kit #WD35X151
through Haier Appliances Parts by calling 877-337-3639 or
visiting haierappliances.com. In Canada, call 800-661-1616.
You can purchase Finish Dishwasher Cleaner at your local
®
grocery store.
UPPER SPRAY HEAD
Do NOT remove the upper spray head.
Clean with warm soapy water using a small plastic bristle
brush.
10
SPRAY ARMS
Because hard water chemicals will clog the spray arm jets and
bearings, it is necessary to clean the spray arms regularly.
Wash the arms in soapy, warm water and use a soft brush to
clean the jets. Replace them after rinsing thoroughly.
To remove the upper spray arm, twist the retaining nut 45°
and pull the spray arm off the water supply tube.
Upper
Rack
Upper Spray Arm
IMPORTANT: When replacing make sure to twist lock the
retaining nut securely onto the water supply tube. Check that
the spray arm is secure and that it rotates freely.
To remove the lower spray arm, remove the lower rack and
lift spray arm out.
Arm
Clips
Retaining
Ring
®
IMPORTANT: When replacing make sure to seat the arm clips
over the retaining ring. Check that the spray arm is secure
and that it rotates freely.
Water Supply Tube
Retaining nut
Lower Spray Arm
49-55125-1