Product Information - Dyson SV10 Manual De Instrucciones

WASHING THE FILTERS
• Your machine has two washable filters; wash the filters at least once a month
according to the following instructions to maintain performance. More frequent
washing may be required where the user: vacuums fine dust, operates mainly in
"Powerful suction" mode, or uses the machine intensively.
WASHING FILTER A
• Ensure the machine is disconnected from the charger before removing the filter. Be
careful not to pull the "ON" trigger.
• Check and wash the filter regularly according to instructions to
maintain performance.
• The filter may require more frequent washing if vacuuming fine dust or if used mainly
in "POWERFUL SUCTION" mode.
• To remove the filter, lift it out of the top of the machine.
• Wash the filter with cold water only.
• Run water over the outside of the filter until the water runs clear.
• Squeeze and twist with both hands to make sure the excess water is removed.
• Lay the filter on its side to dry. Leave to dry completely for a minimum of 24 hours.
• Do not put the filter in a dishwasher, washing machine, tumble dryer, oven,
microwave or near an open flame.
• To refit, place the dry filter back into the top of the machine. Make sure it is seated
properly.
WASHING FILTER B
• To remove the filter, twist counter-clockwise to the open position and pull away from
the machine.
• Wash the inside of the filter under cold running water, rotating the filter to ensure all
pleats are covered.
• Gently tap the filter against the side of the sink several times to remove any debris.
• Repeat this process 4-5 times until the filter is clean.
• Place the filter upright, with the top of the filter facing upwards, and leave to dry
completely for a minimum of 24 hours.
• To refit, return the filter to the open position and twist clockwise until it clicks
into place.
BLOCKAGES – AUTOMATIC CUT-OUT
• This machine is fitted with an automatic cut-out.
• If any part becomes blocked the machine may automatically cut out.
• This will happen after the motor pulses a number of times (i.e switches on and off in
quick succession).
• Leave to cool down before looking for blockages.
• Ensure the machine is disconnected from the charger before looking for blockages.
Failure to do so could result in personal injury.
• Clear any blockage before restarting.
• Refit all parts securely before using.
• Clearing blockages is not covered by your warranty.
LOOKING FOR BLOCKAGES
The motor will pulse when there is a blockage. Please follow the instructions below to
locate the blockage:
• Ensure the machine is disconnected from the charger before looking for blockages.
Be careful not to pull the "ON" trigger.
• Do not operate while checking for blockages as doing so could result in
personal injury.
• Beware of sharp objects when checking for blockages.
• To check for blockages in the main body of the machine, remove the clear bin and
cyclone as per the instructions in the cleaning the clear bin section and remove the
blockage. Please consult the 'Stubborn blockages' section of the illustrations for
further guidance.
• If you cannot clear an obstruction you may need to remove the brush bars, please
follow the instructions below:
– To remove the soft roller cleaner head brush bars, please refer to the 'Washing the
soft roller cleaner head brush bars' section. Remove the obstruction and replace the
brush bars as shown in the 'Washing the soft roller cleaner head brush bars' section.
Ensure that the fastener is fully turned and the base plate and brush bars are secure
before operating the machine.
– To remove the brush bars from the direct drive cleanerhead, use a coin to unlock the
fastener and slide the brush bars out of the cleanerhead. Remove the obstruction.
Replace the brush bar and secure it by tightening the fastener. Ensure it is fixed firmly
before operating the appliance.
• This machine has carbon fiber brushes. Take care if coming into contact with them,
as they may cause minor skin irritation. Wash your hands after handling the brushes.
• Refit all parts securely before using.
• Clearing blockages is not covered by your warranty.
CHARGING AND STORAGE
• This machine will switch "OFF" if the battery temperature is below 37.4°F (3°C). This
is designed to protect the motor and battery. Do not charge the machine and then
move it to an area with a temperature below 37.4°F (3°C) for storage purposes.
• To help prolong battery life, avoid recharging immediately after a full discharge.
Allow to cool for a few minutes.
• Avoid using the machine with the battery flush to a surface. This will help it run cooler
and prolong battery run time and life.
BATTERY SAFETY INSTRUCTIONS
• If the battery needs replacing please contact the Dyson Helpline.
• Use only Dyson chargers for charging this Dyson machine.
• The battery is a sealed unit and under normal circumstances poses no safety
concerns. In the unlikely event that liquid leaks from the battery do not touch the
liquid and observe the following precautions:
– Skin contact – can cause irritation. Wash with soap and water.
– Inhalation – can cause respiratory irritation. Expose to fresh air and seek medical
advice.
– Eye contact – can cause irritation. Immediately flush eyes thoroughly with water for at
least 15 minutes. Seek medical attention.
– Disposal – wear gloves to handle the battery and dispose of immediately, following
local ordinances or regulations.
CAUTION
The battery used in this device may present a risk of fire or chemical burn if
mistreated. Do not disassemble, short contacts, heat above 140°F (60°C), or
incinerate. Keep away from children. Do not disassemble and do not dispose of
in fire.
DISPOSAL INFORMATION
• Dispose of or recycle the battery in accordance with local ordinances or regulations.
• Keep the used batteries away from children as these can still harm children
if swallowed.
• Dyson products are made from high grade recyclable materials. Recycle
where possible.
• The battery should be removed from the product before disposal.
ONLINE SUPPORT
• For online help, general tips, videos and useful information about Dyson.
– www.dyson.com.mx/support
DYSON CUSTOMER CARE
THANK YOU FOR CHOOSING TO BUY A DYSON MACHINE.
After registering your 2 year warranty, your Dyson machine will be covered for parts
and labor (excluding filters) for 2 years from the date of purchase, subject to the
terms of the warranty. If you have any questions regarding your Dyson machine,
visit www.dyson.com.mx for online help, general tips and useful information
about Dyson.
Alternatively, you can contact us via email or phoning Dyson Customer Care with
your serial number and details of where/when you bought the machine.
If your Dyson machine needs a repair, email or phone Dyson Customer Care so we
can discuss the available options. If your Dyson machine is under warranty, and it is a
covered repair, it will be repaired at no cost.
PLEASE REGISTER AS A DYSON MACHINE OWNER
To help us ensure that you receive prompt and efficient service, please register as a
Dyson machine owner.
• Register online at www.dyson.com.mx.
This will confirm ownership of your Dyson machine in the event of an insurance loss,
and enable us to contact you if necessary.

PRODUCT INFORMATION

Please note: Small details may vary from those shown.
13