Wall Moun�Ng - LC-POWER LC-M40-UWQHD-144 Manual De Instrucciones

4. As shown in the figure above, put the base assembly assembled in step 3 into
the corresponding sink of the rear shell, gently press the bracket to make the
sha� assembly clip into the lock, then hold the middle posi�on of the bracket,
gently li� the fuselage twice without tripping, so as to ensure that the buckle
can lock the base assembly; When disassembling, follow the opposite steps.
assembled base
Monitor
5. Hold the support sha� by hand and erect the machine.
Note: in the process of erec�ng the machine, please do not hold the screen
or turn it upside down with your hands to prevent the machine from breaking
the screen.
Make sure the monitor is laid on a flat surface before removing the stand.
6. Wall Moun�ng
This monitor only includes screws which may be used when a�aching
the monitor to a VESA 75*75mm type mount. No VESA mount or
moun�ng accessory is included.
1. Open the package, and then take out the foam and place it on a table.
upper styrofoam
styrofoam underneath
Eng-5