Product Operation - GiBiDi CL200 Instrucciones De Instalación

6
UK
WARNINGS FOR THE USER
In the event of an operating fault or failure, cut the power upstream of the control unit and call Technical Service. Any
repairs must be carried out by specialised personnel using original and certified materials.
The appliance is not to be used by children or people with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction.
Do not touch the card for adjustments and/or maintenance.
WARNING: IMPORTANT SAFETY INSTRUCTIONS.
For people's safety, it is important to follow these instructions.
Please keep this manual.
ELECTRICAL CONNECTIONS: FASTONS
Terminal Position
1
2
M1
3
4
5
6
7
8
M2 9
10
11

PRODUCT OPERATION

The card AS05530 works as interface between the control unit that operates the rising bollard and the electronic cards
inside the top of the same rising bollard.
SIGNALLING LIGHTS MANAGEMENT
Connecting the WARNING LIGHT coming from the control unit between the M3 and M5 inputs, the led signalling lights on
the rising bollard top will be enabled, in a modality that is synchronized and complementary to the WARNING LIGHT
signal.
The lights will flash slowly during the lowering and fast during the rising of the bollard, they will be turned on fixed when the
cylinder is completely out of the casing and off when the cylinder is completely lowered.
OBSTACLE DETECTION DEVICE MANAGEMENT
The GBD rising bollard is equipped with a device that blocks the rising of the cylinder if an obstacle is on the top of the
bollard itself.
For the management of the device it is necessary to connect the outputs M4 and M6 to the PHOTO input of the control
unit.
When an obstacle goes on the top of the bollard, were it inside the casing or were it coming out of it, the sensors on the top
of the bollard will detect the obstacle and will enable the PHOTO output, which will send the due signal to the control unit.
Description
Signal
24 V card power supply input.
24V
Connect the 24 V positive to this clamp.
24 V card power supply input.
24V
Connect the 24 V negative to this clamp.
M3 WARNING LIGHT input
M4
PHOTO output (COM)
M5 WARNING LIGHT input (COM)
M6 PHOTO output
12V 12 V output
24V 24 V output
GND Ground
LED LED signal input
HALL HALL signal input
CL200
24Vdc 3W max
NC Contact
Connection to the cards on
the rising bollard top