Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Before descaling the appliance, the old carbon
filter must be removed from the water reservoir.
The carbon filter removes chlorine and other
contaminants from the water for a pure coffee
taste. After descaling the appliance, a new
carbon filter must be placed in the water
reservoir. New carbon filters are available from
our service station.
Note: Princess will not be responsible for any
damage caused by descaling agents. Damage
caused by not regularly descaling the appliance
is not covered by the guarantee.
Before you proceed, we need you to pay
attention to the following notes:
-
Before descaling the appliance, remove the
mains plug from the wall socket and wait
until the appliance has cooled down.
-
Do not immerse the appliance in water or
any other liquids.
-
Make sure that the grinding function is not
activated when descaling the appliance.
•
Open the cover (25).
•
If necessary, empty the water reservoir (14).
•
Remove the carbon filter holder (20) from
the water reservoir (14).
•
Open the cover (28).
•
Remove the old carbon filter (30).
•
Place the new carbon filter (29).
•
Close the cover (28).
Note: The carbon filter holder must not be
placed in the water reservoir before the
appliance has been descaled.
•
Fill the water reservoir (14) with a suitable
descaling agent.
•
Place the coffee pot (16) on the heating
plate (18).
•
Insert the mains plug into the wall socket.
•
Switch on the appliance by pressing the
on/off button (1).
•
Let the appliance run until 1/3 of the
descaling agent is in the coffee pot (16).
•
Switch off the appliance by pressing the
on/off button (1).
•
Let the descaling agent work for
approximately 30 minutes.
•
Switch on the appliance by pressing the
on/off button (1).
•
Let the appliance run until the remaining
descaling agent is in the coffee pot (16).
The appliance stops automatically when
the water reservoir (14) is empty.
•
Rinse the appliance twice according to the
below procedure:
- Fill the water reservoir (14) with clean
water up to the maximum mark on the
water level indicator (15).
- Place the empty coffee pot (16) on the
heating plate (18).
- Switch on the appliance by pressing the
on/off button (1).
- Let all water run through the appliance.
The appliance stops automatically when
the water reservoir (14) is empty.
•
Place the carbon filter holder (20) in the
water reservoir (14).
•
Close the cover (25).
•
Switch off the appliance by pressing the
on/off button (1).
•
Keep the coffee quantity selector (3) and
the coffee strength selector (4) pressed
until the indicator (D) disappears from the
display (8) (fig. C).
•
Clean the outside of the appliance with
a damp cloth. Dry the outside of the
appliance with a clean, dry cloth. The
appliance is ready for use.
Safety instructions
General safety
•
Read the manual carefully before use.
Keep the manual for future reference.
•
Only use the appliance and the accessories
for their intended purposes. Do not use the
appliance and the accessories for other
purposes than described in the manual.
•
Do not use the appliance if any part or any
accessory is damaged or defective. If a part
or an accessory is damaged or defective,
it must be replaced by the manufacturer or
an authorised repair agent.
•
Children should be supervised to ensure
that they do not play with the appliance.
17
Tabla de contenido
