Idiomas disponibles
Idiomas disponibles
Step 13 - Cut Old Ignition Wires at the Switch.
Working under the control panel, identify the RED and BLACK wires that exit
the old ignition switch. Using a pair of scissors, cut the RED and BLACK
wires as close as possible to the old ignition switch. Remove and discard the
loose RED and BLACK wires from the grill. The switch will remain in the grill.
NOTE: Be careful NOT to cut any of the new wires you have just installed.
Step 14 - Reinstall the LP Tank.
Step 15 - Attach the LP Regulator
Tighten the LP tank retainer screw and attach the LP Regulator.
An instructional video demonstrating this procedure is
available at www.charbroil.com/gas-patio-bistro-recall.html
You have now completed the Electronic Ignition Module
Replacement Procedure. Enjoy your Grill.
Cut RED and BLACK
wires near the switch.
7
BLACK Wire
13
RED Wire
14
15
15
15
