Hitachi PC-ALH Manual De Instrucciones página 14

INSTALLATION OF WIRELESS RECEIVER KIT
14
5. Draw out the connecting cable from the wiring hole of the indoor unit, and lead the cable to the installing position of
the receiver kit.
6. Install the air panel (option) onto the indoor unit.
7. Attach the receiver kit in the following procedure.
 Draw out the connecting cable from the pocket and connect the connecting cable and the wire of the receiver kit.
After connecting the cable, wrap the connector with the cover and fix them with a band.
 Hook the band on the rear side of the receiver kit at
the pin of the air panel as shown bellow.
Band
8. Attach other pocket cover (3 positions) to the air panel.

NOTE:
When removing the receiver kit after installing the air
panel:
a) Remove the screws of  (4 positions) from
the front side of the air panel.
b) Move the Receiver kit with hands in the
arrow direction  and remove the nails (2
positions) of pocket cover for corner, and
slide the receiver kit in the arrow direction .
PMML0174A_r0_11-07.indb 14
Connecting
Band
cable
Cover
Band
Pin
Air panel
Corner pocket
Connecting cable
Receiver kit
 Hook L- shaped nail on the rear side of receiver kit
at the square hole of the air panel, and fix it with the
screw.
L-shaped nail
Screw
Nail (2 position)
22/11/2007 12:49:43