Stocking The Wine Cellar; Wine Cellar Care; Base Grille; Cleaning - Kitchen Aid KUWR204EPA Manual De Uso

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

4. Replace the rack by inserting the rack into the supports and
sliding it toward the rear of the wine cellar.

Stocking the Wine Cellar

NOTES:
For optimum wine storage, place white wines on the upper
rack of the wine cellar and place red wines on the lower rack
of the wine cellar.
The wine racks can be stocked with the bottles facing either
direction, however, to optimize storage adjacent bottles
should be facing in opposite directions.
To Stock the Wine Cellar:
1. Start stocking the wine cellar with the bottom display rack.
2. Starting on the left-hand side, place the first bottle on the
bottom of the rack with the neck of the bottle facing the front
of the wine cellar.
3. Place the next bottle on its side with the neck of the bottle
facing the back of the wine cellar. Alternate the direction of
the bottles, in this manner, until the display rack is full.
4. Slide the bottom rack into place and pull the next rack
forward.
5. Continue stocking each remaining rack as described in the
above steps.

WINE CELLAR CARE

Base Grille

You must remove the base grille to access the condenser coils
for cleaning.
To Remove the Base Grille:
1. Open the wine cellar door to access the base grille.
2. Using a Phillips screwdriver, remove the two screws.
3. Push both tabs in toward the center to release the base grille
from the cabinet and remove.
A
To Replace the Base Grille:
1. Open the wine cellar door.
2. Position the base grille so that both tabs align and the base
grille snaps into place. Replace the two screws. Tighten the
screws.

Cleaning

WARNING
Explosion Hazard
Use nonflammable cleaner.
Failure to do so can result in death, explosion, or fire.
Clean the wine cellar about once a month to avoid buildup of
odors. Wipe up spills immediately.
To Clean Your Wine Cellar:
1. Unplug wine cellar or disconnect power.
2. Remove all racks from inside the wine cellar.
3. Hand wash, rinse, and dry removable parts and interior
surfaces thoroughly. Use a clean sponge or soft cloth and a
mild detergent in warm water.
To avoid damaging wooden tines and trim pieces, wipe
them off with a clean sponge or soft cloth and warm
water. Do not use detergent or immerse the entire rack
into water when cleaning.
B
A
A. Tabs
B. Screws
11
11
Tabla de contenido
loading

Este manual también es adecuado para:

Kuwl204epa

Tabla de contenido