secudo I/O-Modul D 130 Manual Del Usuario página 119

Explanation
Radio module alarm triggered when input
is set.
Silenced when the alarm is triggered.
Radio module's fault signal indicating a flat
battery.
Fault signal received from a networked radio
module/D 110 smoke detector that has a
flat battery.
Ready for operation/standard mode/radio
module is operating correctly.
Explanation
The radio detector is in programming mode.
The button has been pressed and held down
for approx. 2-3 seconds.
Programming has been successfully
completed.
The radio module reverts to the factory settings.
The button has been pressed and held down
for a minimum of approx. 5 seconds.
Solution
Silence the alarm signal for approx. 10 - 13 minutes. Any
networked radio modules/D 110 smoke detectors will also
be silenced.
Silence the alarm signal for approx. 10 - 13 minutes. Any
networked radio modules/D 110 smoke detectors will also
be silenced.
Wait at least 20 minutes before replacing the battery so as to
avoid disrupting the radio transmission.
Wait at least 20 minutes before replacing the battery of the
device which initiated the signal so as to avoid disrupting
the radio transmission. If the signal persists, all of the radio
group's radio modules/D 110 smoke detectors will need to
be reset to their factory settings and reprogrammed.
Solution
The radio module will automatically revert to standard mode
after approx. 1 minute.
Press and hold down the button for a minimum of approx. 5
seconds to restore factory settings.
Once the button is released, the radio module reverts to
standard mode without radio communication.
119