Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CAMERA INSTALLATION
Standard package
Installation
Guide
Camera
Instructions
Wrench
Optional
Desiccants
CD manual
3-pin Terminal
block
Waterproof kit
Step1: Find the installation sticker on the sales package, and paste it to where you want to install this camera. Then, drill screw holes as
indicated on the sticker (Figure 1).
Note: The installation sticker could also be downloaded from www.surveillance-download.com/user/542_installation_sticker.pdf.
Step2: Arrange the cables to be connected as shown in Figure 2 depending on the installation location for installation later.
Step3: Remove the camera cover by using the wretch supplied within the sales package, and find the three screw holes on the camera base.
Screws, Wall Plugs,
Rubber Rings (×3)
Step4: Connect the cables.
-
A waterproof kit for Rj45 network cable might be provided in the sales package. Please check the section "WATERPROOF
ACCESSORIES" to know how to use it.
-
To connect alarm devices, a terminal block might be provided in the sales package. Please connect the terminal block first and
start wiring.
Then, align the screw holes on the camera base with the holes drilled in Step1, and install the camera.
Note: Three rubber rings are provided within the sales package. They should be used with the screws during installation for waterproof purposes.
To check the complete user manual and free PC CMS software (CMS Lite),
please scan the QR code or go to
Figure 1
Figure 2
Figure 4
www.surveillance-download.com/user/m521.swf
Figure 3
724Z
Tabla de contenido
