Velleman MONSB4 Guia De Inicio Rapido

1. Introduction & Features
At the end of its life cycle, dispose of this product in accordance with local and national disposal regulations.
Thank you for buying the MONSB4! Please read the manual thoroughly before bringing this device into service.
If the device was damaged in transit, don't install or use it and contact your dealer.
2. Safety Instructions
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer will
not accept responsibility for any ensuing defects or problems.
• All modifications of the device are forbidden for safety reasons. Damage caused by such modifications is not
covered by the warranty.
• This device must be earthed.
• Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
• Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if necessary.
• Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug only.
• Keep the device away from children and unauthorised users.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device is protected against extreme temperatures, dust and moisture.
• Use the original packaging if the device is to be transported.
• Only use the device for its intended purpose. Using the device in an unauthorised way will void the warranty.
3. Front Panel
On its front panel, the MONSB4 features brightness and contrast controls and a
power switch with a power light.
4. Rear Panel
Fig.2
5. Use
• Connect a video source (camera etc.) and, if needed, a recording device (VCR, DVD recorder).
• Make sure the ventilation openings of the device are never blocked to prevent overheating.
• Plug the power plug of the device into a mains outlet.
• Make sure the video source is live and switch the MONSB4 on. Set the brightness and contrast controls to your
liking.
MONSB4
MONSB4 – 10" B/W MONITOR
On the rear panel are located:
(from left to right)
- video BNC input connector
- video BNC output connector
- CCIR/EIA selection switch
1
Fig.1
VELLEMAN