Eldom rovi HO70B Manual De Instrucciones página 7

GENERAL DESCRIPTION
1. Indicator light
2. handle
3. power supply switch
4. Thermostat
5. heating fins
6. place for winding the cord with the
socet for the plug
7. castors
8. ventilation openings
S
TECHNICAL DETAIL
- Rated power: 1500W
- Mains supply: 230v ~ 50hz
INTENDED USE
The HO70 oil heater is intended for heating
residential premises. It has been produced to
the highest requirements and use of advanced
technology. Due to the manufacture pursuant
to high standards, it is safe and easy in use.
USING THE DEVICE
• After unpacking the device, make sure if it was not damaged during the transport. In case of any doubts, refrain from its use until
contacting a service point.
• Install the feet with castors (7) - fot. 2
• Place the unit on a flat, stable and heat-resistant floor, min. 2 m away from furniture and flammable objects,
• Set the thermostat (4) in the "MIN" position,
• Connect the device to the power supply source of the parameters compliant with those stated in the user guide.
• Using the switch (3) select the heating power:
- "I" for 600 W
- "II" for 900 W
- "I"+"II" for 1500 W
• The device will start when temperature is selected with the thermostat knob (4). Setting the highest temperature of operation is
done with the thermostat knob set in the "MAX" position and switching on both buttons (3)
• Operation of the device is signalled with the indicating lamp (1).
The device is operating only whe set vertically. It has a safeguard cutting off the power supply when it is overturned.
During operation of the device, do not cover the heater with clothing or other textiles. Do not cover ventilation openings.
The device has a thermal safeguard cutting off the power supply when it is overheated. In this case, set the thermostat knob in the
"MIN" position, disconnect the device from the power supply and eliminate the cause of overheating. Leave the device to cool down
before switching the device on again.
INSTALLATION
1. carefully place the device with its feet upwards (soft surface
is best used to avoid damaging of the protection coat).
2. Install the metal castor bases with clamps and nuts: fot. 2.
The bases should be spaced as in fot. 1.
3. Set the castors in the installed bases and tighten with the
enclosed nuts.
4. Turn the heater back to the proper vertical position.
OPERATING INSTRUCTION
OIL FILLED RADIATOR HO70B/HO70C
1
2
3
4
fot. 1
1
fot. 2
8
6
2 3
EN
5
7
4
•
EN 7