Cleaning And Maintenance - Eldom ori BK3S Manual De Instrucciones

Ocultar thumbs

Contenido

página de 45

/ 45
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

Replace the cover (2) and the plug (1); (see: installation of the glass container).

Switch on the motor with the control switch (9). The position of the switch must be

adjusted to the food products in the container (see the table: speed control).

The maximum time of continuous work of the device may be 2 minutes. If this time

is exceeded, immediately switch off the device and wait at least 5 minutes before its

restarting.

Exceeding the maximum time of work may result in damaging of the device and loss of

the guarantee.

Before removing the container from the motor body, make sure that the device is

switched off (the control switch in the position "0")

CAUTION

If the blade is jammed, immediately switch off the blender, disconnect it from the

network and leave the device to cool down for at least 15 minutes. Eliminate the

cause of jamming.

SPEED CONTROL

POSITION 1

POSITION 2

PULSE

(hold the switch in the "P" position)

RECOMMENDATIONS

To prevent splashes, do not fill the jug above the mark of the 1250 ml level.

If liquids are processed that foam or expand during mixing, do not fill the jug to a level

higher than 2/3 of the maximum volume.

To achieve the best results in preparing mush and puree, place small portions to the

container instead of large ones.

In case of processing solid products, first cut them into smaller bits (2-3 cm).

When using the blender, always keep your hand on the cover of the device.

Be cautious when mixing hot liquids.

To mix ingredients of solid consistence, using the blender in the pulse mode is

recommended to prevent jamming of the blades.