Technical Data - Eldom ori BK3S Manual De Instrucciones

OPERATING INSTRUCTION
EN
JAR BLENDER BK3S
GENERAL DESCRIPTION
1. Plug
2. Cover
3. Glass container
4. Flange
5. Cutting unit sealing
6. Blade
7. Cutting unit base
8. Body
9. Control switch
10. Assembled container (1,5l)

TECHNICAL DATA

- power: 500W
- mains voltage: 220-240 V~
50/60 Hz
- maximum time of continuous
operation: 2 minutes
- break before continuation of
operation: 5 minute
MAINTENANCE
Before the first use, all parts of the blender that come in contact with food must be
thoroughly cleaned (see: Cleaning and maintenance).
INSTALLATION OF THE GLASS CONTAINER:
Place the flange (4) on the bottom of the container (3),
-
Place the sealing (5) on the blade (6) and insert in the base of the cutting unit (7),
-
Place the assembled cutting unit base on the bottom of the container (3) and tighten up
-
Place the glass container on the body (8). The flange must strongly adhere to the body.
-
Place the cover (2) on the container and carefully press down.
-
Insert the plug (1) to the hole in the cover (2) and turn clockwise to close.
-
NOTE. The blender will not run without the properly set flange (4).
OPERATION:
- Make sure that the blender is switched off (the switch (9) in the position "0").
- Make sure that the plug of the appliance is inserted in the socket with earthing.
Place food products in the container (3), not exceeding the maximum position.
-
Temperature of the ingredients should not be higher than 50°C.
10 EN
10
9
8
1
2
3
4
5
6
7