Eldom swan OB100 Manual De Instrucciones página 10

INSTRUCTION MANUAL
EN
VACUUM CLEANER OB100
GENERAL DESCRIPTION
1
Upright-vacuum-cleaner handle
2 Upright-vacuum-cleaner ON/
OFF button
3 Power control
4
Arm lock
5 Upright-vacuum-cleaner body
6 Brush lock
7
Brush handle
8 Brush
9
Brush backlight
10 Handheld-vacuum-cleaner lock
11
Handheld-vacuum-cleaner ON/
OFF button
12 Dust-container lock
13
Indicator
14 Handheld vacuum cleaner
15
HEPA filter
16
Sponge filter
17 Filter cartridge
18
Dust container
19 Bracket
20
Clipboard
21
Brush-shaft lock
22 Brush shaft
23
Charging station - upper section
24 Seat
25
Charging station - bottom
section
26 Handheld-vacuum-cleaner
suction nozzle
27 Suction-nozzle brush
28
Power supply
TECHNICAL DATA
Rated power: 110W
Supply voltage: 100-240V, ~50 Hz
Maximum vacuum: 12kPa
Operating voltage: 22.2V
Charging voltage: 26.5V
Volume: <80dB
Operating times after full charge
- at high speed for up to 20 minutes,
- at low speed for up to 40 minutes.
Dust-container capacity: 0.5l
Battery: Li-ION 22.2 V, 2200 mAh
ASSEMBLY
- Unpack the unit and check the components for damage.
Assemble the charging station (21+23) - Fig. 1. To disassemble the station, turn it round, move the lever, and pull out the
-
upper section.
Holding the handle (1) lift the arm, and lock it. To fold the arm, press the button (4) - Fig. 2.
-
- Move the lock (6) in the brush (8), insert the shaft (22), and lock it (6) - Fig. 3.
NOTE
Do not use the upright vacuum cleaner with the shaft (22) out of the brush (8).
Install the complete brush (8) in the housing (7). To remove the brush, press the lock (6) and slide it out - Fig. 4.
-
- Insert the filter cartridge (17), sponge filter (16), and HEPA filter (15), into the container (18), respectively - Fig. 5, and then
assemble the entire set in the handheld vacuum cleaner (14) - Fig. 6.
NOTE
Do not use the upright and handheld vacuum cleaner without the filters (15, 16, 17) and container (18) in place.
Place the assembled handheld vacuum cleaner (14) in the body (5). To disconnect the handheld vacuum cleaner (14), press the
-
button (10) and slide it out - Fig. 7.
Plug the tip of the power cord into the socket in the charging station (22), then connect the power cord to the mains according
-
to the parameters given in the manual - Fig. 8.
Make sure that the assembled upright vacuum cleaner is turned off, and place it onto the charging station on the bracket (19).
If the power cord is connected to the station, charging will start, signalled by the indicator (13).
10 EN
10
11
12
14
13
15
16
17
18
9
19
1
2
3
21
4
5
28
6
7
27 26
8
20
22
23
24
25