Tecnical Charecteristics - Sima ATA 400 Manual De Instrucciones

Curl is disordered Continuous
and steps out of curl piping
guide
No wires cutting Continuous
take place piping
Wire gets entangled Continuous
piping
Binder power is Continuous
weak piping
Continuous
piping
Continuous
piping
Wire twisting takes Continuous
place piping
Continuous
piping

8. TECNICAL CHARECTERISTICS

Dimension (mm)
Weight (Kg)
Engine power (V)
Max. tie diameter (mm)
Diameter (mm)
Length (m)
Ties per coil
Checks if the wire hits
reinforcing bars at
binding
Check if cutter section is
functioning
Checks if the wire hits
reinforcing bars at
binding
Check size of the
reinforcing bars
Check if curl guide is left
open at binding
Check you understood
the instruction manual.
Check size of the
reinforcing bars
Check you understood
the instruction manual.
PORTABLE RE-BAR TIER
SPOOL WIRE
Wire was repelled
after hit reinforcing
bars
Cutter section is
blocked with
extraneous object
Wire was repelled
after hit reinforcing
bars.
Reinforcing bars are
not of designated size
Spool wire has not
been replaced
Wrong handling or
inadequate
application of the tool
Reinforcing bars are
not of designated size
Wrong handling or
inadequate
application of the tool
290x100x277
2,1
9,6
40
0,8
100
190
10-
Pay attention to avoid
the wire hits the
reinforcing bars.
Remove object which
block Cutter section.
Pay attention to avoid
the wire hits the
reinforcing bars
Use appropriate
diameter scope
Replace spool wire
Read manual again
Use appropriate
diameter scope
Read manual again
ENGLISH