Idiomas disponibles
Idiomas disponibles
Always use batteries SIMA, never connect the machine directly to the power supply..
Recharge your batteries, exclusively, with the charger supplied by SIMA.
Damaged wire could easily cause fire, keep the wire away from heat, oil or moving objects. Change immediately if the
wire be damaged.
Avoid short circuits. Do not store the battery with metallic items such as coins etc ... Place the battery cover when it
not in use.
The machine is supplied with Ni-MH batteries and intelligent battery charger. Use properly these devices to extend the
useful life and avoid unexpected damage.
Replace the battery and use the machine in a temperature range between 0 ° C and 40 ° C.
Connect the battery charger AC220 and 50Hz only. Never use a power supply with different characteristics, may cause
an incident.
5. CONTROLS.
1. Release lever. Fig.3
2. Window. Fig.3
3. Tie wire. Fig.3
4. Warning led. Fig.3
5. Torque dial. Fig.3
6. Main Switch. Fig.3
7. Trigger lock. Fig.3
8. Grip. Fig.3
9. Battery. Fig.3
10. Trigger. Fig.3
11. Curl guide. Fig.3
12. Workspace. Fig.3
13. Arm. Fig.3
6. SETTING AND USE
WARNING!: Must follow all safety recommendations outlined and comply with safety standards of occupational
hazards.
START-UP PERIOD: ATA Model 400 no need any START-UP period, it is especially designed to obtain maximum
benefits from the start..
REGULAR USE OF THE MACHINE: The rebar tier has been designed and built to tie corrugated and flat iron bars.
Any other use not expressly indicated it will consider as not suitable. Any supplies or accessories added or modified
without written authorization from the manufacturer is considered inappropriate and dangerous,
so in these cases or for misuse if damage or injury occur, SIMA SA is exempt any responsability as a producer. DO -T
USE THIS TOOL IN THE RAIN. Always work with good light conditions.
6.1 PROCEDURE TO MAKE A RIGHT TIED
Place the body of the tier at an angle of 45 ° to the cross bar and press the machine so that the crossing is between
the arm and the curl guide (see Fig.16).
The machine should be positioned so that the handle is parallel to the bar plane (see Fig.13).
8-
ENGLISH
Capítulos
