Cable Management - Uline H-7605 Manual De Instrucciones

2. Position mounting bracket over holes with anchors.
Fasten bracket to wall with two 6.4 x 12 mm washers
and two ST 5.5 x 60 mm hex screws using 10 mm
wrench. (See Figure 3)
Figure 3
6.4 x 12 mm
Washer
Plastic
Anchor
ATTACHING MONITOR
NOTE: Ensure monitor has a VESA hole pattern
of 100 x 100 mm or 75 x 75 mm. (See Figure 4)
NOTE: If monitor is attached to a fixed base,
remove monitor from base.
CAUTION! Be careful not to scratch screen
during installation.
Figure 4
75 x 75 mm or 100 x 100 mm
1. Easy-adjust monitor mount includes a built-in
counterweight system for free-range motion. Arm in
mount may need to be adjusted to allow monitor to
stop at desired position. Attach monitor to plate.
(See Figure 5)
Figure 5
Allen
5.3 x 14 mm
Wrench
Use appropriate bolts for monitor.
PAGE 2 OF 6
INSTALLATION CONTINUED
ST 5.5 x 60 mm
Hex Screw
Washer
2. To adjust the counterweight, use 5 x 5 Allen wrench
on screw above middle joint. Turn towards "–" if
monitor raises up. Turn towards "+" if monitor lowers.
Adjust until mount can be stopped at desired
position. (See Figure 6)
Figure 6
Adjust swivel
with Allen
Wrench

CABLE MANAGEMENT

1. To remove covers, use a Phillips head screwdriver
to unscrew the two screws securing covers to the
monitor arm. This allows user to slide cables through
covers. Once complete, re-secure the covers to the
monitor arm using the Phillips head screws.
(See Figure 7)
Figure 7
1-800-295-5510
uline.com
Adjust Tilt with
Allen Wrench
±180º -85º ~15º
±90º
±180º
Take off covers and put cable in.
Insert screw to lock covers.
0521 IH-7605